Bu çalışmada, %0 (Referans), %1,
%2, %3, %4 ve %5 oranlarında öğütülmüş kolemanit minerali çimento ile ikame
edilerek beton karışımları hazırlanmıştır. Beton karışımlar 150 x 150 x 150 mm
boyutlu küp kalıplara yerleştirilmiştir. Sertleşmiş beton numuneler 28 gün suda
kür edilerek, sonrasında 90. güne kadar sodyum klorür (NaCI) çözeltisine maruz
bırakılmıştır. Ayrıca aynı özelliklerde üretilen kontrol beton örnekleri ise
90. güne kadar su küründe bekletilmiştir. Kontrol ve NaCI çözeltisine maruz
bırakılmış beton numuneler üzerinde Schmidt çekici, ultrases geçiş hızı ve
basınç dayanımı deneyleri gerçekleştirilmiştir. Gerçekleştirilen deneyler
üzerinden beton numunelerin NaCI çözeltisinin etkisi ile meydana gelen kayıplar
hesaplanmıştır Sonuç olarak, çimentoya ikame edilen %5 kolemanit ikameli
numunenin, kolemanit içermeyen numuneye göre basınç dayanımını azalttığı, ancak
%4’ kadar ikame oranlarında ise dayanımı arttırdığı tespit edilmiştir. NaCI
çözeltisi kürü sonucunda, en yüksek basınç dayanımı ve en az basınç dayanımı
kaybının %3 kolemanit ikameli beton karışımına ait olduğu tespit edilmiştir.
Kolemanit mineralini tedarik eden Eti Maden İşletmeleri Genel Müdürlüğüne teşekkür ederiz.
In this study,
concrete mixtures were prepared by substituting milled colemanite mineral with
cement in the ratio of 0% (Reference), 1%, 2%, 3%, 4% and 5%. The concrete
mixtures are placed in 150 x 150 x 150 mm cube molds. Hardened concrete samples
were cured in water for 28 days and then exposed to sodium chloride (NaCl)
solution until day 90. In addition, the control concrete samples produced with
the same characteristics were kept in the water cure until the 90th day.
Schmidt hammer, ultrasonic pulse velocity and compressive strength tests were
performed on concrete samples exposed to control and NaCl solution. The losses
occuring by the effect of NaCl solution of concrete samples were calculated. As
a result, it was found that the strength of the sample with 5% colemanite decreased
compared to the sample without colemanite, but the strengthes of samples with
up to 4% colemanite increased. As a result of cured to NaCl solution, the
highest compressive strength and minimum compressive strength losses were
determined to belong to the sample with 3% colemanite.
Birincil Dil | Türkçe |
---|---|
Konular | Mühendislik |
Bölüm | Makaleler |
Yazarlar | |
Yayımlanma Tarihi | 31 Ocak 2020 |
Yayımlandığı Sayı | Yıl 2020 Cilt: 8 Sayı: 1 |